Minolta DIMAGE F300 - V2 Instruction Manual download pdf (Page 53)

The focus-lock function prevents the AF system from focusing. Focus lock can be used with off-cen-

ter subjects or when a special focusing situation prevents the camera from focusing (p. 27).

When using single-shot AF with Area AF in the multi-function

recording mode, place the subject in the focus frames and press

the shutter-release button partway down. The focus frames will

disappear and a red AF sensor will indicate the point of focus.

Without lifting your finger from the shutter-release button, recom-

pose the subject within the image area. Press the shutter-release

button all the way down to take the picture.

The focus signal in the lower right corner of the LCD monitor and

the green focus lamp next to the viewfinder indicate the focus sta-

tus.

Focus lock

Focus locked.

Focus icon: white

Focus lamp: steady

Focus icon: red

Focus lamp: blinking

Cannot focus. The subject is too close or a special sit-

uation is preventing the AF system from focusing.

When using focus area selection, place the active focus area on

the subject. Press and hold the shutter-release button partway

down; the active focus area will turn red and the other areas will

disappear. The focus signal should turn white to indicate the focus

is locked.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 127 128

No comments

Minolta DIMAGE F300 - V2 Instruction Manual Page 53