Minolta Maxxum Flash 400AF Instruction Manual download pdf (Page 16)

E32 E33

WIRELESS FLASH

When another wireless flash is being used nearby, your flash might

fire with a light signal from the built-in flash of other cameras. In this

case, the channel can be changed to prevent your settings from

interference.

1. Make sure that the

wireless/remote flash lamp,

both [CH1] and [CH2] are not

lit.

• Press the wireless/remote flash but-

ton [WL], in case that they are lit.

3. Attach the flash to the camera

and press the shutter-release

button partway down.

• This operation transmits the informa-

tion of channel settings to the cam-

era.

2 Press the wireless/remote

flash button for three seconds.

• The channel settings will be changed

and so will the channel indicator

lamp.

WIRELESS/REMOTE FLASH MODE

Notes On Wireless Flash

The MS-2 mini-stand is useful when the flash unit is off the camera.

The mini-stand has a tripod configuration with a threaded hole to

attach the flash unit.

Attach Remove

• Pre-flash fires when wireless/remote flash mode is selected. A flash

meter and color meter cannot be used.

• Shutter speed is 1/60 or 1/45 of a second or less (this differs between

cameras). Use with high-speed sync is possible only with the

Maxxum/Dynax 7 and 5 in normal wireless mode (not ratio).

• The zoom position for the 3600HS (D) is automatically set to 24mm.

• When slow sync is used with wireless flash, press the AE lock button

to generate a test flash and take the photo while holding down the AE

lock button.

Changing the channel setting

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23

No comments

Minolta Maxxum Flash 400AF Instruction Manual Page 16