Minolta PagePro 1200 Series Service Manual download pdf (Page 10)

PagePro 1200 Series Safety

1-4. Other Precautions

• When handling circuit boards, observe the guidelines presented in “HANDLING of PWBs”.

• The PC Drum is a very delicate component. Observe the precautions given in “HANDLING OF

THE PC DRUM” because mishandling may result in serious image problems.

• Note that replacement of a circuit board may call for readjustments or resetting of particular

items, or software installation.

1-5. Precautions for Service

• When performing inspection and service procedures, observe the following precautions to prevent

mishandling of the machine and its parts.

• Depending on the model, some of the precautions given in the following do not apply.

1. Precautions Before Service

• When the user is using a word processor or personal computer from a wall outlet of the same line,

take necessary steps to prevent the circuit breaker from opening due to overloads.

• Never disturb the LAN by breaking or making a network connection, altering termination, install-

ing or removing networking hardware or software, or shutting down networked devices without

the knowledge and express permission of the network administrator or the shop supervisor.

2. How to Use this Book

DIS/REASSEMBLY, ADJUSTMENT

• To reassemble the product, reverse the order of disassembly unless otherwise specified.

TROUBLESHOOTING

• If a component on a PWB or any other functional unit including a motor is defective, the text only

instructs you to replace the whole PWB or functional unit and does not give troubleshooting pro-

cedures applicable within the defective unit.

• All troubleshooting procedures contained herein assume that there are no breaks in the harnesses

and cords and all connectors are plugged into the right positions.

• The procedures preclude possible malfunctions due to noise and other external causes.

3. Precautions for Service

• Keep all disassembled parts in good order and keep tools under control so that none will be lost or

damaged.

• After completing a service job, perform a safety check. Make sure that all parts, wiring and

screws are returned to their original positions.

• Do not pull out the toner hopper while the toner bottle is turning. This could result in a damaged

motor or locking mechanism.

• If the product is to be run with the front door open, make sure that the toner hopper is in the

locked position.

• Do not use an air gun or vacuum cleaner for cleaning the ATDC Sensor and other sensors, as they

can cause electrostatic destruction. Use a blower brush and cloth. If a unit containing these sen-

sors is to be cleaned, first remove the sensors from the unit.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 103 104

No comments

Minolta PagePro 1200 Series Service Manual Page 10