Minolta EP1052 Specifications download pdf (Page 170)

Interleaf EP1052 DIS/REASSEMBLY, ADJUSTMENT

96.11.01

D-51

(6) Adjustment of the Multi Bypass Table Reference Position

z Requirement

1151D024AA

D Ready a test chart (A3 or 11” 17”) as shown on the left.

Draw a line on the chart at a point 20 mm from the right

edge as shown.

D Dimension A on the copy should measure

20 ± 2.0 mm.

1. Place the test chart face down on the Original Glass and

align its rear left corner with the marker on the Original

Width Scale on the left side of the platen.

Then, lower the Original Cover.

2. Using the Multi Bypass Table, make two full size copies.

3. Using the second copy, compare the position of the refer-

ence line on the copy with that on the test chart.

4. If the line does not meet the requirement, loosen the two

screws (OPTION : three screws) that secure the Multi By-

pass Table and move the Table as necessary in the direc-

tion of the arrows.

NOTE

If dimension A on the copy is smaller than 18 mm, move

the Table to the front. If it is more than 22 mm, move the

Table to the rear.

When an Automatic or Duplexing Document Feeder is

mounted, it involves changing the Original Glass. This in

turn results in the position of the Original Length Scale be-

ing slightly shifted toward the rear. This is corrected by

installing the Original Positioning Plate.

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 232 233

No comments

Minolta EP1052 Specifications Page 170