Minolta Dimage 5 Instruction Manual Page 63

  • Download
  • Add to my manuals
  • Print
  • Page
    / 75
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 62
Set the mode dial to the data-transfer position.
The data-transfer menu will be displayed.
CONNECTING THE CAMERA TO A COMPUTER
125124
DATA-TRANSFER MODE
When the camera is properly connected to the computer, a drive icon will appear. If the
computer does not recognize the camera, disconnect the camera and restart the com-
puter. Repeat the connection procedure above.
Start up the computer.
The computer must be turned on before connecting the camera.
Insert the CompactFlash card into the camera.
Confirm that the correct card is in the camera. To change
the CompactFlash while the camera is connected to a
computer, see page 134.
Attach the other end of the USB cable to the computer’s USB
port.
Make sure the plug is firmly attached.
The camera should be connected directly to the computer’s USB
port. Attaching the camera to a USB hub may prevent the camera
from operating properly.
A fresh set of batteries should be used when the camera is connected to a computer.
The use of the AC adapter (sold separately) is recommended over the use of batteries.
For users with Windows 98 and Mac OS 8.6, read the respective sections on how to
connect to the operating system before connecting the camera to a computer
(Windows 98 - p. 126, OS 8.6 - p. 129).
After using the four-way keys of the controller to high-
light the USB option in the USB section of the data-
transfer menu, press the the right key of the controller.
“Enter” should appear on the right side of the screen.
Press the center of the controller to send a signal to
the computer to initiate the USB connection.
A screen will appear to indicate the beginning of the
connection process.
When the signal has been received by the computer, the
camera’s
monitors will turn off.
COMPUTER
1
2
3
4
5
6
7
3
4
5
Open the card-slot door. Attach the smaller plug of the USB
cable to the camera.
Make sure the plug is firmly attached.
Trans
USB
USB
Enter
Initializing USB
connection
Page view 62
1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 74 75

Comments to this Manuals

No comments