Minolta MAXXUM 500SI - PROGRAM SELECTION User Manual download pdf (Page 12)

FreeRide -271.9

90 -40 1.2

Table showing the positioning of the cart for different calibration methods.

MANUAL Calib.

FREE Mode

6.2.2.2. Recording

Recording mode is designed to record the movements of slider in order to play it back later in Playback mode.

Movement control (SPEED and DAMPING) is exactly the same as in Free Ride mode, so the user can change

SPEED and DAMPING parameters at any time during the movement. In order to finish the recording and return

to the menu press the joystick. The controller can store 59 seconds of the recording. Recorded movement is stored

in the controller until the power supply is switched off.

6.2.2.3. Playback

Playback mode plays back movements of HSO-4 rotational slider saved in Recording mode. Once you enter

Playback mode, the screen displays information about the length of the recording or the lack of it.

FreeRide 149

200 -169 1.2

Video Rec 1276.1

148 69 2.5

Video Rec 668.7

Memory Full

Selecting FREE Mode the user does not determine

any reference points, therefore the position at which

the slider stands at that moment is marked as „0”

(starting point). Any position to the left from that starting

point is determined as a negative number whereas

any position to the right, as a positive number.

The direction of movement is indicated with currently

set speed value. If the currently set speed

is in the opposite direction it is marked with the sign "-".

Selecting MANUAL Calib. for a calibration method,

please note that the position of "0" means the left

extreme point of reference. The value grows

as the slider moves closer to the right extreme point

of reference. The direction of movement is indicated

with currently set speed value. If the currently set speed

is in the opposite direction it is marked with the sign "-".

If length of the recorded movement exceeds 59 seconds,

a message on the screen will appear informing the user

that the controller memory is full.

To stop the recording before the end of 59 seconds, press

the joystick. In order to play back the recorded movement,

return to the main menu and enter Playback mode.

Current position of the slider, measured in mm [1]

Maximum speed of the slider set by the user [2]

Currently set speed [3]

Acceleration / deceleration time [4]

Slide Kamera HKN-2 stepper drive for HSO-4 rotational slider

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Minolta MAXXUM 500SI - PROGRAM SELECTION User Manual Page 12

Comments to this Manuals

Related products and manuals for Unknown Minolta MAXXUM 500SI - PROGRAM SELECTION