Minolta MAXXUM 500SI - PROGRAM SELECTION User Manual download pdf (Page 13)

Playback 0.0

No Records

[Recording]

> [Playback] 59s

Playback 590.2

Go Home? N<- ->Y

Playback 7267.4

press OK to Play

Playback 58.4

press OK to exit

Playback 722.1

Time: 7/59s

The controller displays information about the current

position of the slider [1] and the current/ overall time

of the recording [2]. Once the recorded movement

stops press the joystick to return to VIDEO menu.

When you select [Playback] there will be a message displayed on the screen: "Go Home?".

The controller requires the user decision whether the slider should return to the position where the recording

of movement started (-> Y) or whether to start playing back the movement from the current position of the slider

(N <-). Select the option by moving the joystick in the appropriate direction. You can return to VIDEO menu at any

time by pressing the joystick.

6.2.2.4. VideoLoop

During VideoLoop mode slider moves from one reference point to the other without stop. It automatically turns

back and starts moving in the opposite direction once it reaches the end of the movement range. There is no need

for the user to determine the direction of the movement. The user can change SPEED and DAMPING parameters

at any time during the movement. SPEED knob allows to set the speed value of the slider [1] within the range

of 2 -200mm/s. DAMPING knob allows to set the acceleration/deceleration time [2] within the range

of 0.1-10 seconds. Pressing the joystick causes the driving motor to stop immediately and the centroller returns

to VIDEO menu. In VideoLoop mode there is no "-" sign when the cart moves in the opposite direction.

If you selected FREE Mode when setting startup parameters, it is important to remember that the drive has

no reference points set. Consequently, it will move only in one direction and will not turn back. Use SPEED knob

to adjust the speed of the slider paying special attention so it does not hit any obstacle.

VidLoop 856.6

36 3.1

1 2

Current ly set speed of the slider [1]

Acceleration/deceleration time [2]

Slide Kamera HKN-2 stepper drive for HSO-4 rotational slider

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Minolta MAXXUM 500SI - PROGRAM SELECTION User Manual Page 13