Minolta MAXXUM 500SI - PROGRAM SELECTION User Manual download pdf (Page 16)

After the user determines the desired starting position, information about current parameters will appear

on the LCD. In order to start, move the joystick in a direction you selected earlier. After the first step, move

the joystick again to initiate another step. The user can freely move a step forward or backward (by moving

the joystick right or left) or skip a few steps forward or backward (by holding the joystick longer in a selected

direction).

Sample screen presented above informs that the user selected right as movement direction [1]. If the user chose

left, there would be: dirL- on the screen. Current position of the slider is 80mm [2] from the left reference point

in MANUAL Calib., or starting point in FREE Mode. Length of step set by the user is 40mm [4]. The drive currently

performs second step out if thirty steps set [3]. The drive has already taken three shots out of five shots set [5].

The user can stop the program at any time by pressing the joystick for 2 seconds. When the drive has taken all

the photos and stops the program, there will be a message on the screen with the current position of the slider.

Press the joystick to return to the main menu.

7. Maintenance and operation

Maintenance of Slide Kamera HKN-2 stepper drive for HSO-4 rotational slider reduces to keeping the drive clean.

Use professional maintenance products for this type of equipment, such as Dry Lube with Teflon or antistatic cloth.

Elements of the drive do not require any lubrication. To remove any impurities, you can use compressed air.

8. Transport

Slide Kamera HKN-2 stepper drive for HSO-4 rotational slider must be transported in a transport case that provides

a proper protection of the equipment against any damage.

ANIM dirR 80.0

2/30 40.0 3/5

3 4

Selected movement direction [1]

Current position of the slider [2]

Current step/ number of programed steps [3]

Length of step [4]

Number of shots already taken/

number of all shots to take [5]

ANIM dirR 327.0

press OK. to exit

Any changes in design and repairs are made only and exclusively by the manufacturer.

Failure to comply with the recommended guidelines outlined in this manual

will result in loss of warranty.

Slide Kamera HKN-2 stepper drive for HSO-4 rotational slider

1 2 ... 11 12 13 14 15 16 17 18 19 20

No comments

Minolta MAXXUM 500SI - PROGRAM SELECTION User Manual Page 16