Minolta DIMAGE VIEWER 2.1 Instruction Manual download pdf (Page 36)

ASIC RECORDING

USING THE BUILT-IN FLASH

FLASH RANGE - AUTOMATIC OPERATION

To use the flash, simply pull up the unit by the tabs on each

side. The flash position must be set manually, and once up,

the flash unit will always fire regardless of the amount of

ambient light. The following indicators will appear in the

upper left corner of the EVF and LCD monitors to show the

flash status.

The camera will automatically control the flash output. For well-exposed images, the

subject must be within the flash range. Because of the optical system, the flash range is

not the same at the lens’ wide-angle position as it is at the telephoto position.

Wide-angle position

Telephoto position

0.5m ~ 3.8m (1.6 ft. ~ 12.5 ft.)

0.5m ~ 3.0m (1.6 ft. ~ 9.8 ft.)

Flash warning. In backlit situations, a white indicator appears to recommend

the use of the flash.

The white flash indicator appears when the flash is ready to fire.

The red flash indicator appears when the flash is charging.

After taking a picture, the OK indicator appears briefly if the flash properly

exposed the subject.

In low-light conditions or indoors, the flash is needed to illuminate the subject and reduce

blurring through camera shake. The flash can also be used as a fill light in direct sunlight

to soften harsh shadows. Always remove the lens hood when using the built-in flash; the

hood may cast a shadow if mounted.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 179 180

No comments

Minolta DIMAGE VIEWER 2.1 Instruction Manual Page 36