Minolta DIMAGE VIEWER 2.1 Instruction Manual download pdf (Page 64)

DVANCED RECORDING

Continuous-advance mode allows a series of images to be captured while holding down

the shutter-release button. Continuous advance acts like a motor drive on a film camera.

TIFF and RAW & JPEG image quality cannot be used. RAW cannot be used with UHS

continuous advance.

CONTINUOUS ADVANCE

Turn the function dial to the drive mode position

(1). Press the function button in the center of the

dial (2). Turn the front control dial to select the

continuous-advance drive mode (3). Use the rear

control dial (4) to switch between standard, high-

speed, and UHS continuous advance. Press the

shutter-release button partway down or press the

function button to set the mode.

Continuous advance - captures a maximum of three images at 1.8fps. When

used with continuous autofocus, the camera adjusts the focus during the

series. The live image is briefly displayed between frames.

High-speed continuous advance - captures a maximum of three full-size

images at 2.7fps. The rate of capture decreases with images smaller than

3264 X 2448. Focus is locked with the first frame regardless of the focusing

mode. The monitor turns off during the series.

UHS continuous advance - captures multiple 640 X 480 size images at 7fps.

The approximate number of frames that can be captured at one time depends

on the image quality setting: extra fine - 100, fine - 160, standard - 180. The

digital zoom and flash cannot be used. Shutter speeds must be 1/30 second

or faster. Very bright light sources within the image may cause streaking.

Black areas caused by a loss of data may be apparent.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 179 180

No comments

Minolta DIMAGE VIEWER 2.1 Instruction Manual Page 64