Minolta DIMAGE VIEWER 2.1 Instruction Manual download pdf (Page 57)

Use the front control dial to decrease the shutter-speed until

“bulb” is displayed.

Use the rear control dial to set the appropriate aperture

required for the exposure.

To take the picture, press and hold the shutter-release

button for the duration of the exposure. Releasing the

shutter button will end the exposure.

The monitors will be blank during the exposure. The shutter

sound effect will signal the end of the exposure. The

monitors will remain blank for up to 30 seconds while noise-

reduction processing is applied to the image.

Bulb photographs can be taken in the manual-exposure mode (M). The maximum

exposure time depends on the camera sensitivity setting, see page 55. The use of a

tripod and a remote cord is recommended for bulb exposures. The camera’s exposure

system cannot be used to calculate bulb exposures. The use of a separate light meter is

recommended.

BULB EXPOSURES

ATTACHING A REMOTE CORD (SOLD SEPARATELY)

The optional remote cords (RC-1000S or RC-1000L) can be

used to reduce vibrations from touching the camera during

long exposures. Before using the cord, attach the ferrite core

supplied with the camera as described on page 167.

Remove the remote-control terminal cover using the notch on

the right side of the cover. The cover is attached to the body

to prevent loss. Insert the plug of the cord into the terminal.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 179 180

No comments

Minolta DIMAGE VIEWER 2.1 Instruction Manual Page 57