Minolta DIMAGE VIEWER 2.1 Instruction Manual download pdf (Page 75)

FLASH RANGE AND CAMERA SENSITIVITY

Flash range (wide angle)ISO setting

100

200 / AUTO

400

800

0.5m ~ 2.1m / 1.6 ft. ~ 6.9 ft.

Flash range (telephoto)

0.5m ~ 1.7m / 1.6 ft. ~ 5.6 ft.

0.5m ~ 2.7m / 1.6 ft. ~ 8.8 ft.

0.5m ~ 3.8m / 1.6 ft. ~ 12.5 ft.

0.5m ~ 5.4m / 1.6 ft. ~ 17.6 ft.

0.5m ~ 7.6m / 1.6 ft. ~ 25 ft.

0.5m ~ 2.1m / 1.6 ft. ~ 6.9 ft.

0.5m ~ 3.0m / 1.6 ft. ~ 9.8 ft.

0.5m ~ 4.2m / 1.6 ft. ~ 13.8 ft.

0.5m ~ 6.0m / 1.6 ft. ~ 19.6 ft.

For correct flash exposures, the subject must be within the flash range. The flash range

can be extended by changing the camera sensitivity. When the camera sensitivity is set

to auto, the ISO is set between ISO 64 and 200.

The flash range is measured from the CCD. Because of the optical system, the flash

range is not the same at the lens’ wide-angle position as it is at the telephoto position.

To extend the versatility of the camera, an accessory flash unit (sold separately) can be

used. Always remove the accessory flash when the camera is not in use, and replace the

accessory-shoe cap to protect the contacts.

ATTACHING AN ACCESSORY FLASH UNIT

Slide the accessory-shoe cap off as shown. Mount

the flash unit on the accessory shoe by sliding it

forward until it stops.

The following flash units are compatible with this camera:

Maxxum/Program Flash 2500(D)

Maxxum/Program Flash 3600HS(D)

Maxxum/Program Flash 5600HS(D)

Macro Ring Flash 1200 with Macro Flash Controller

Macro Twin Flash 2400 with Macro Flash Controller

System Accessories

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 179 180

No comments

Minolta DIMAGE VIEWER 2.1 Instruction Manual Page 75